Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain

Hinumerik
Hitachi
Mazak

Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Mitsubishi M50

Parameter Value Comments  
I/O Parameters Screen 1/6
9001 2

Input Port

9001 1 Input Device
9003 2 Out Port
9004 0 Out device
9005 2 Tape Mode

 
I/O Parameters Screen 2/6

9101 Out/In  
9201 Out/In  
9102 2 Baud rate 4800
9202 2  
9103 1 1 Stop Bit
9203 1  
9104 1 Use Parity = Yes
9204 1  
9105 1 Parity = Even
9205 1  
9106 2 7 Databits
9206 2  
9108 3 Use xOn/xOff (DC1 and DC3)
9208 3  
9109 1  
9209 1  

RS232 Cable.
9pin computer to 25pin CNC

 

The simple three wire cable shown above is the most common for this type of control and is compatible with the xOn/xOff (DC1/DC3) flow control suggested on this page.

If you intend using RTS/CTS flow control then an alternative cable shown here is compatible with both xOn/xOff and RTS/CTS.

   

dnc software for acramatic DNC Software for Windows 8, Windows 7, Vista and Windows XP. 32 and 64bit versions
for Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
Single or Multi-Tasking to Communicate with one or more than one control at the same time.
   

MiniMRP is an easy to use Inventory Manager with Multi-Level BOM Manager and other 'MRP'
features usually only available in larger MRP/ERP packages.

Inventory, Single and Multi-Level BOM for less that $200