Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain
Hinumerik
Hitachi
Mazak
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac


CNC / DNC Settings for Fagor 80xx

Parameter
Value
Comments

In the control settings select
9 (Special Modes)
1 (General Parameters)

P000
Valid Baud Rates 2400, 4800 (Same as the DNC Software)
P001
7
7 Databits
P002
2
Even Parity
P003
2
Stop Bits
After making changes - reset the controller

 

Cable shown here is most common supporting xOn/xOff (DC1/DC3) flow control. If your CNC is configured to use RTS/CTS (Hardware) flow control then see the alternative cable diagram here.

RS232 Cable.
9pin computer to 25pin CNC

   
dnc software for acramatic

DNC Software for Amada, Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
DNC to CNC Memory or Drip Feed. Includes Single CNC + Multi-CNC Server at no extra cost.
easyDnc 5.0 Only $190 USD (License is per computer. No CNC Limit)